Electrical and electronic equipment (EEE) > Power management components > PWM controllers > Radiation-hardness-assured (RHA), 30-V, 2-A, double-ended, 1-MHz PWM controller
Summary
The Texas Instruments UC1825B-SP Pulse Width Modulation (PWM) control device is optimized for high-frequency, switched mode power supply applications.
In particular, the controller has been designed to minimize propagation delays through logic circuitry and the use of comparators, while maximizing both the slew rate of the error amplifier and the operating bandwidth.
The controller is designed to be used in either voltage mode systems or current-mode, with the additional capability for input voltage feed-forward.
It includes protective circuitry such as a soft start pin (that can double as a maximum duty-cycle clamp), a TTL-compatible shutdown port, and a current limit comparator with a 1V threshold.
The component also features totem pole outputs that are designed to source and sink high peak currents from capacitive loads, such as the gate of a power MOSFET. In addition, the on-state is designed as high level.
The UC1825B-SP's logic is fully latched in order to prohibit multiple pulses at an output and to provide jitter-free operation.
An undervoltage lockout section, that includes 800 mV of hysteresis, is designed to ensure low startup current requirements. Outputs are high impedance during undervoltage lockout.
Applications
- Radiation-hardened DC-DC converters
- Satellite buses and payloads
- Communications payload
- Optical imaging payload
- Radar imaging payload
- Space launch vehicles
- Supports various topologies:
- Flyback, forward, buck, boost
- Push-pull, half-bridge, full-bridge with external interface circuit
Orderable Part Numbers
- 5962R8768106V9A
- 5962R8768106VYC
- UC1825BHKT/EM
Key features
- QML-V qualified, SMD 5962-8768106
- 5962R8768106VYC:
- Radiation hardness assurance (RHA) up to 100-krad(Si) total ionizing dose (TID)
- Compatible with voltage- or current-mode topologies
- Practical operation switching frequencies to 1 MHz
- 50-ns propagation delay-to-output
- High-current dual totem pole outputs (2-A peak)
- Wide bandwidth error amplifier
- Fully latched logic with double-pulse suppression
- Pulse-by-pulse current limiting
- Soft start/maximum duty-cycle control
- Undervoltage lockout with hysteresis
- Low start-up current (1.1 mA)
Testing & qualification
Below are the technical documentations available for this product:
- Radiation & reliability report
- SEE Test Report of the UC1825B-SP High Speed PWM Controller
- UC1825B-SP Neutron Displacement Damage Characterization
- UC1825B-SP total ionizing dose (TID) radiation report
- Application note
- Single-Event Effects Confidence Interval Calculations
- Heavy Ion Orbital Environment Single-Event Effects Estimations
- Selection guide
Disclaimer: satsearch is not responsible for any mistakes on this page, although we do our best to ensure correctness. Please report any mistakes to us.
Last updated: 2021-12-21
UC1825B-SP
Radiation-hardness-assured (RHA), 30-V, 2-A, double-ended, 1-MHz PWM controller
Specs
Export